The Happymodel Moblite7 HDZero Whoop is a 75mm HD brushless whoop weighing just 29.5 grams. It features the HDZero Whoop Lite VTX and Nano Camera and built-in SPI ELRS 2.4GHz or FrSky 2.4GHz receiver. With powerful EX1002 KV20000 motors, and Superbee F4 Lite flight controller, this should be a great performing high-definition whoop you can fly just about anywhere.
FC Specifications:
-
SPI ELRS version Firmware target: CrazybeeF4SX1280
-
SPI FRSKY version Firmware target: CrazybeeF4FR
-
MCU: STM32F411CEU6 (100MHz, 512K FLASH)
-
Sensor: ICM42688P
-
Power supply: 1S Lipo Lihv battery input (DC 2.8V~4.35V)
-
Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
-
Built-in Betaflight OSD(SPI Control)
-
Built-in SPI Frsky/ExpressLRS receiver
-
Built-in 5V 1A BEC
- Built-in voltage detection
4-in-1 ESC Specifications:
- MCU upgraded to EFM8BB21
- Power supply: 1S LiPo/LiPo HV (2.8v~4.35v)
- Currents: 5A continuous peak 6A (5 seconds)
- Support BLHeliSuite programmable
- Factory firmware: O_H_5_REV16_8.HEX
- Default protocol: DSHOT150/DSHOT300/DSHOT600
ELRS SPI Receiver Specifications:
-
Packet Rate option: 25Hz/50Hz/150Hz/250Hz/500Hz
-
RF Frequency: 2.4GHz
-
Telemetry output Power: <12dBm
-
Receiver protocol: SPI ExpressLRS
- Could bind with ELRS V2.0 firmware TX module
FRSky SPI Receiver Specifications:
-
SPI BUS receiver Frsky D8/D16 compatible
-
Compatible Non EU transmitter D8 model and EU-LBT(Frsky_x_lbt)
-
Channels: 8ch or 16ch
-
Failsafe support
-
No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m
- Based on CC2500 RF module Compatible with Futaba S-FHSS , Redpine protocol
Motor Specifications:
-
Model: EX1002 20000KV
-
Configuration: 9N12P
-
Stator Diameter: 10mm
-
Stator Length: 2mm
-
Shaft Diameter: ?1.5mm
-
Motor Dimension(Dia.*Len): ?13.5mm*12.5mm
-
Weight(g): 2.5g
- No. of Cells(Lipo): 1S only
Gemfan 1610-2 Propeller Specifications:
-
Weight: 0.24g
-
Material: PC
- Pitch: 1 inch
-
Props Dia: 40mm
- Center Hole Dia: 1.5mm
HDZero Nano Lite Camera Specifications:
- Dimensions: 14x16x11 mm
- Weight: 1.5gram
- Sensor: 0.5 inch, up to 10650 mV/Lux-sec ultra-high sensitive CMos sensor
- Excellent low light performance
- FOV:
4:3: D:130° H:108° v:84°
16:9:D:122° H:108° V:65°
HDZero Whoop Lite VTX Specifications:
- 1S Input
- 25mW/200mW RF Output-SmartAudio Support
- 25.5×25.5 M2 Soft Mounting- Antenna Retention
- Removable Shielding Box- 32.5×32.5mm(29x29mm inner)
- 4.5grams/4mm Thickness (without shielding)
Package Includes:
- 1 x Happymodel Moblite7 HDZero 1S 75mm Brushless HD FPV Whoop Drone - Chosen Receiver
- 1 x Moblite7 Spare Canopy
- 1 x Gemfan 1610 propeller Set (4cw+4ccw)
- 1 x Propeller disassemble tool
- 1 x Screwdriver
Updated USB Orientation:
![](https://www.pinoyfpv.com/store/images/Moblite7_bottom.jpg)
This product was added to our catalog on Tuesday 18 April, 2023.