The wait is over!
I would like to Introduce the Mr. Steele V4 STOUT 2306 (1750KV) 6S FPV freestyle motor.
I take great pride in my work and am always trying to raise the bar. After two years of seemingly nonstop research & development, I am proud to present this fine piece of Miniquad motor engineering.
V4 motor highlights/changes
-
base redesign 16x16(only) mounting holes (structural changes for more durability)
-
Complete bell redesigned (durability and smoothness in mind)
-
Thicker single strand copper winding
-
increased EFFICIENCY & POWER
-
Complete Interchangeable motor pants redesign (thicker & more crash/low temperature resistant, better gap fitment, + more protection coverage for the “tall pants”)
-
better assembly tolerances
-
Overall QC improvements
-
9mm steel bearings
-
Eco-Friendly packaging
-
Motor weight 31.8g
-
(full-length cables) compared to Stout V3 at 30.5g
Pants weights
-
Low - 1g vs (0.8 v3)
-
Tall - 2g vs (1.8 v3)
All in all this motor is an absolute gem only increasing the weight by a tad over 1g from the previous model while achieving more power, efficiency, and most importantly durability.
V3- V4 COMPATIBILITY
-
V4 and V3 motors are completely cross-compatible.
-
V3 bells - V4 stator
-
V4 bells - V3 stator
( everything is interchangeable except pants) The pants are stator-specific and can be interchangeable but with less than desired effect.
Enjoy & Thank you for your continued support.
-Steele
Specifications
-
Stator Size (Diameter): 23mm*6mm
-
Kv: 1750kv
-
Magnets: N52SH Curved
-
Windings: 15turn DLRK
-
Shaft Length (mm): 11.5mm
-
Shaft Diameter (mm): 4mm
-
Shaft material: Steel
-
Bearing : NMB684
-
Weight (With Wires) (g): 32.4g
-
Cells (Lipo): 6S
-
Max Current (A): 45A
-
Max Burst Current (A): 50A
-
Internal Resistance (Rm): 100m?
-
Wire Spec (AWG): 20#-135mm
-
Base Mounting Pattern: 16x16mm
-
Base Mounting Thread: M3 Thread
-
Motor Overall Dimensions: ?28.6mm*17.5mm
Includes
-
1 x Motor
-
1 x Tall Motor Pants
-
1 x Short Motor Pants
-
4 x motor screws
