MG Chemicals 422C Silicone Conformal Coating, 40 ml (repack)

For your FC, ESC and other electronic components that you don't want to get wet.

Size:: 40 mililiters (repacked from wholesale container)
Protects electronics against moisture, corrosion, dirt, dust, thermal shock, short circuits,high-voltage arcing, and static discharge.
Maximum service temperature of 200 °C
Fluoresces under UV-A light
Easy to apply and can be handled in only 10 minutes
Validated for selective robotic coating equipment, FPV Drone, rc cars and boats
422C Silicone Conformal Coating is a 1-part, acrylic-silicone blend conformal coating that cures to a durable, flexible and smooth finish. It is easy to apply and can be handled in only 10 minutes. It may be removed with appropriate strippers or soldered through for repair or rework.
422C is designed for applications where both high service temperature and flexibility are required. It puts minimum stress on components during thermal cycling, making it ideal for applications that involve a wide temperature range. It provides strong protection against moisture, corrosion, dirt, dust, thermal shock, short circuits, high-voltage arcing, and static discharge.

Ideal for high temperature environments. Silicone Conformal Coating (422C) is a flexible finish product that provides a protective coating for printed circuit boards against moisture, corrosion, and thermal shock. It protects and insulates electrical and electronic components and assemblies, including generators, motors, transformers, relays, and solenoid coils. For spraying, liquid can be thinned using M.G. Thinner Cleaner. Thin up to one half part thinner to one part coating. Best results will be obtained by applying to thoroughly cleaned and dried parts or materials. It is essential that surfaces be free of any trace of grease or organic substances. At room temperature, the product will tack free in approximately 10 minutes, and full cure will be achieved in approximately 48 hours. Curing may be accelerated by applying moderate heat with either a convection oven or infrared lamps. We recommend curing in a convection oven at 65 degree C for one hour, but other temperature and time combinations can work well. Heat curing will improve the physical strength of this coating. ROHS Compliant.